KHE 5-40 (600391500) Combination hammer

(220-240 V / 50 - 60 Hz); Plastic Carry Case

Order no.: 600391500 EAN: 4061792199255

Max. single blow energy (EPTA):

8.5 J

Maximum impact rate:

3000 bpm

Rated input power:

1100 W

Drill-Ø concrete with hammer drills:

40 mm / 1 9/16 "

Tool holder:

SDS-max

Combination hammer with 2 functions: hammer drilling and chiselling
Metabo VibraTech (MVT): integrated damping system to reduce vibrations in order to protect the user's health
Vario-Constamatic (VC)-Full wave electronics for working at customised speeds to suit the application materials, and speeds that remain almost constant even under load
Thumbwheel for preselection of the speed and impact rate
Electronic soft start for precise spot-drilling
Metabo S-automatic safety clutch: mechanical decoupling of the drive for safe working should the drill stop unexpectedly
Low-dust chiselling and drilling with external dust extraction ESA max (accessories)

more product information

Manual Spare-parts list

Description
Technical data
Scope of delivery
Accessories
Accessories Detail

Combination hammer with 2 functions: hammer drilling and chiselling
Metabo VibraTech (MVT): integrated damping system to reduce vibrations in order to protect the user's health
Easily accessible locking switch for chiselling in continuous mode
Vario-Constamatic (VC)-Full wave electronics for working at customised speeds to suit the application materials, and speeds that remain almost constant even under load
Thumbwheel for preselection of the speed and impact rate
Electronic soft start for precise spot-drilling
Optimum heat dissipation and low weight thanks to die cast magnesium gear housing
Metabo S-automatic safety clutch: mechanical decoupling of the drive for safe working should the drill stop unexpectedly
Restart protection: prevents unintentional start-up after power supply interruption
Low-dust chiselling and drilling with external dust extraction ESA max (accessories)
Wear Indication for Carbon Brush
Service display, e.g. to indicate when the carbon brush needs to be replaced, and an LED indicating mains voltage
Early warning system thanks to service LED for targeted planning of the carbon brush replacement 8 working hours before switching off

The machine shown may differ in equipment and technical details depending on the configuration.
Kindly pay attention to delivery scope and product description.
Accessories included only if listed in the delivery scope.

Characteristics

Max. single blow energy (EPTA)

8.5 J

Maximum impact rate

3000 bpm

Rated input power

1100 W

Drill-Ø concrete with hammer drills

40 mm / 1 9/16 "

No-load speed

350 - 540 rpm

Speed at rated load