KHE 5-40 (600391530) Combination Hammer

(220-240 V / 50 - 60 Hz); Plastic Carry Case

Order no.: 600391530 EAN: 4061792199262
Max. single blow energy (EPTA):
8.5 J
Maximum impact rate:
3000 bpm
Rated input power:
1100 W
Drill-Ø concrete with hammer drills:
40 mm / 1 9/16 "
Bit retainer:
SDS-max
  • Combination hammer with 2 functions: hammer drilling and chiselling
  • Metabo VibraTech (MVT): integrated damping system to reduce vibrations in order to protect the user's health
  • Easily accessible locking switch for chiselling in continuous mode
  • Vario-Constamatic (VC)-Full wave electronics for working at customised speeds to suit the application materials, and speeds that remain almost constant even under load
  • Thumbwheel for preselection of the speed and impact rate
  • Electronic soft start for precise spot-drilling
  • Metabo S-automatic safety clutch: mechanical decoupling of the drive for safe working should the drill stop unexpectedly
  • Low-dust chiselling and drilling with external dust extraction ESA max (accessories)
  • Wear Indication for Carbon Brush
  • Service display, e.g. to indicate when the carbon brush needs to be replaced, and an LED indicating mains voltage
  • Early warning system thanks to service LED for targeted planning of the carbon brush replacement 8 working hours before switching off
  • Combination hammer with 2 functions: hammer drilling and chiselling
  • Metabo VibraTech (MVT): integrated damping system to reduce vibrations in order to protect the user's health
  • Easily accessible locking switch for chiselling in continuous mode
  • Vario-Constamatic (VC)-Full wave electronics for working at customised speeds to suit the application materials, and speeds that remain almost constant even under load
  • Thumbwheel for preselection of the speed and impact rate
  • Electronic soft start for precise spot-drilling
  • Optimum heat dissipation and low weight thanks to die cast magnesium gear housing
  • Metabo S-automatic safety clutch: mechanical decoupling of the drive for safe working should the drill stop unexpectedly
  • Restart protection: prevents unintentional start-up after power supply interruption
  • Low-dust chiselling and drilling with external dust extraction ESA max (accessories)
  • Wear Indication for Carbon Brush
  • Service display, e.g. to indicate when the carbon brush needs to be replaced, and an LED indicating mains voltage
  • Early warning system thanks to service LED for targeted planning of the carbon brush replacement 8 working hours before switching off
The machine shown may differ in equipment and technical details depending on the configuration.
Kindly pay attention to delivery scope and product description.
Accessories included only if listed in the delivery scope.
Characteristics
Max. single blow energy (EPTA)
8.5 J
Maximum impact rate
3000 bpm
Rated input power
1100 W
Drill-Ø concrete with hammer drills
40 mm / 1 9/16 "
No-load speed
350 - 540 rpm
Revolutions at rated load
540 rpm
Bit retainer
SDS-max
Collar diameter
61 mm / 2.4 "
Weight (without power cable)
7.1
Cable length
6 m / 19.7 ft
Vibration
Hammer drilling concrete
14.6 m/s²
Uncertainty of measurement K
1.5 m/s²
Chiseling
9.7 m/s²
Uncertainty of measurement K
1.5 m/s²
Noise emission
Sound pressure level
95 dB(A)
Sound power level (LwA)
106 dB(A)
Uncertainty of measurement K
3 dB(A)
  • Side handle
  • Duster
  • Plastic carry case
  • Drilling depth guide
  • Lubricant for tool shank end