Products
Electronic Combination Hammer KHE 55
Article Number: 6.00055.00
- Suitable for bits and accessories with SDS max shank end, spline shank end or ratio thread
- Suitable for bits and accessories with spline shank bit and with 19 mm hexagonal and cylindrical end Ã? 16.5 mm
- Rotation stop
- Metabo CODE! system: Electronic theft protection, code activated key (accessory)
- Vario Tacho Constamatic (VTC) full-wave electronics
- Thumbwheel for preselection of speed
- Pneumatic high-performance hammer mechanism
- Magnesium die cast gear housing
- Dust seal protects from the finest dust particles
- Active vibration damping
- Ergonomic housing design for fatigue-proof operation
- Rubber-coated handle
- torque limiting clutch
- No-volt release switch
- Auto-stop carbon brushes
Specification:
| Torque |
60Nm/531 in-lbs |
| Drill diameter in |
|
| - Concrete with hammer bits |
40 mm |
| - Brickwork with drill bits |
90 mm |
| Speeds at no load |
135 - 275 /min |
| Rated input power |
1.050 W |
| Output power |
590 W |
| Speed at rated load |
275 /min |
| Maximum impact rate |
2.600 /min |
| Single-blow energy |
1 - 9 J |
| Collar diameter |
58 mm |
| Bit retainer |
SDS-max |
| Weight (excluding mains lead) |
5,9 kg |
Scope of delivery:
- Additional handle
- Drill depth-stop
- Lubricant for tool shank end
- Duster
- Plastic case
|
Product Catalogue
Hammers
KHE 55
|
